Locate Service Centers | Site Map
Login | Browse and Buy | Promotions | Catalog | Line Card PDF | Supplier Diversity | Premium Brands
  Applied Industrial Technologies The website for Applied Industrial Technologies
   
   Products > ... General Troubleshooting Charts > Load Drops with Control Valve

Load Drops with Control Valve in Neutral Position

Possible Causes:Remedy:

Leaking or broken oil lines from control valve to cylinder.

Check for leaks. Tighten or replace lines. Examine mating surfaces on couplers for irregularities.

Oil leaking past cylinder packings or O-rings.

Replace worn parts. If wear is caused by contamination, clean hydraulic system and determine the contamination source.

Oil leaking past control valve or relief valves.

Clean or replace valves. Wear may be caused by contamination. Clean hydraulic system and determine the contamination source.

Oil leaking past load holding valve.

Check for proper adjustment. Remove and replace cartridge with spare. (Support boom before removing cartridge.) Do not attempt to repair.

Control lever not centering when released.

Check linkage for binding. Make sure valve is properly adjusted and has no broken or binding parts.




Locations | Terms of Access | Terms of Sale | Privacy Policy | Supplier Terms | Site Map | Home | Return Policy
Copyright © 1999-2014 Applied Industrial Technologies. All Rights Reserved.
Get Acrobat® Reader®