Find a Service Center
Alternate Products
- Series E Radially Assembled Retaining Ring
- 0.140 in Shaft Size
- 0.025 in Thick
- Carbon Steel
- Phosphate Finish
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Tape Length of Stack | 8.38 in |
| Shaft Dia. | 0.140 in |
| Groove Depth | 0.017 in |
| Inch/Metric | Inch |
| Material | Carbon Steel |
| Outside Dia. | 0.27 in |
| Thrust Groove Safety Factor of 2 Pg Lb | 60 lbf |
| Load Capacity [Max] | 170 lbs |
| Edge Margin | 0.034 in |
| RPM Limit | 32000 rpm |
| Limiting Speed | 32000 rpm |
| Clearance Installed in Groove | 0.285 in |
| Plating | Phosphate |
| Type | Radially Assembled |
| Finish | Phosphate |
| Thrust Ring Safety Factor of 3 Pr Lb | 173 lbf |
| Tape Width | 1 in |
| Package Type | Stacked |
| Thickness | 0.025 in |
| Tape Rings Stack | 200 |
| Length of Stack | 8.38 in |
| Series | E |
| Weight | 0.005 LB |
| EAN or UPC | 721717005415 |
