Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
Radially installed into machined grooves on shafts (external)
Accommodate lower thrust loadings than axial retaining rings
Do not have lug holes: Easy to install using retaining ring applicators
Provide protruding “shoulders” for effective retention of assemblies
Economical alternative to Axially Assembled external tapered section rings
Thickness
0.0150 in
Clearance Installed in Groove
0.24 in
Shaft Dia.
0.125 in
Inch/Metric
Inch
Series
E
Finish
Phosphate
Limiting Speed
35000 rpm
Load Capacity [Max]
65 lb
Package Type
Snap Pack
Material
Carbon Steel
Plating
Phosphate
Edge Margin
0.03 in
Type
Radially Assembled
Groove Depth
0.015 in
Weight
0.562 LB
EAN or UPC
721717229521
Pre-Packed Quantities
My Applied Catalog
We're here for you
with Service Centers across the country - We have your back
Find a Service Center
