Find a Service Center
Alternate Products
- Series E Radially Assembled Retaining Ring
- 0.250 in Shaft Size
- 0.025 in Thick
- Carbon Steel
- Phosphate Finish
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Thrust Groove Safety Factor of 2 Pg Lb | 115 lbf |
| Material | Carbon Steel |
| Thickness | 0.025 in |
| Load Capacity [Max] | 255 lbs |
| Groove Depth | 0.02 in |
| Finish | Phosphate |
| Outside Dia. | 0.527 in |
| Series | E |
| Package Type | Stacked |
| RPM Limit | 25000 rpm |
| Shaft Dia. | 0.250 in |
| Tape Rings Stack | 250 |
| Tape Width | 1 in |
| Length of Stack | 6.25 in |
| Type | Radially Assembled |
| Inch/Metric | Inch |
| Tape Length of Stack | 6.25 in |
| Plating | Phosphate |
| Thrust Ring Safety Factor of 3 Pr Lb | 259 lbf |
| Edge Margin | 0.04 in |
| Clearance Installed in Groove | 0.54 in |
| Limiting Speed | 25000 rpm |
| Weight | 0.019 LB |
| EAN or UPC | 721717020692 |
