Find a Service Center
Alternate Products
- Series E Radially Assembled Retaining Ring
- 0.500 in Shaft Size
- 0.042 in Thick
- Carbon Steel
- Phosphate Finish
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Outside Dia. | 0.8 in |
| Edge Margin | 0.104 in |
| Inch/Metric | Inch |
| Package Type | Stacked |
| Thrust Groove Safety Factor of 2 Pg Lb | 600 lbf |
| Limiting Speed | 14000 rpm |
| Thickness | 0.042 in |
| RPM Limit | 14000 rpm |
| Material | Carbon Steel |
| Plating | Phosphate |
| Tape Width | 2 in |
| Clearance Installed in Groove | 0.82 in |
| Length of Stack | 8.4 in |
| Shaft Dia. | 0.500 in |
| Thrust Ring Safety Factor of 3 Pr Lb | 1127 lbf |
| Groove Depth | 0.052 in |
| Load Capacity [Max] | 1110 lbs |
| Finish | Phosphate |
| Tape Length of Stack | 8.4 in |
| Tape Rings Stack | 200 |
| Type | Radially Assembled |
| Series | E |
| Weight | 0.025 LB |
| EAN or UPC | 721717033449 |
