Find a Service Center
Alternate Products
- Series SE Radially Assembled Retaining Ring
- 0.219 in Shaft Size
- 0.025 in Thick
- Carbon Steel
- Zinc Dichromate Finish
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Shaft Dia. | 0.219 in |
| Limiting Speed | 26000 rpm |
| Clearance Installed in Groove | 0.45 in |
| RPM Limit | 26000 rpm |
| Package Type | Stacked |
| Series | SE |
| Finish | Zinc Dichromate |
| Tape Width | 1 in |
| Tape Rings Stack | 250 |
| Groove Depth | 0.015 in |
| Load Capacity [Max] | 225 lbs |
| Tape Length of Stack | 6.25 in |
| Plating | Zinc |
| Inch/Metric | Inch |
| Outside Dia. | 0.437 in |
| Material | Carbon Steel |
| Thrust Groove Safety Factor of 2 Pg Lb | 75 lbf |
| Length of Stack | 6.25 in |
| Thrust Ring Safety Factor of 3 Pr Lb | 228 lbf |
| Edge Margin | 0.03 in |
| Thickness | 0.025 in |
| Type | Radially Assembled |
| Weight | 0.011 LB |
| EAN or UPC | 721717012024 |
