MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
7300-PJ and PJD Series bearings are used for very heavy one-directional thrust loads or combined radial and thrust loads where thrust is predominant.
Capacity
Standard Capacity
Width
0.91 in, 23 mm
Duplex Type
Single
Enclosure
Open
Temperature Range [Max]
450 °F
Contact Angle
40 Degree
No. of Rows
Single
Row Type
1
Precision
Standard
Outer Ring Width
0.91 in, 23 mm
Static Load Rating [Max]
6860 lbf
Snap Ring
No Snap Ring
Precision Level
Standard (ABEC 1)
Preload Level
Light
No. in Set
Single Bearing
O.D.
3.54 in, 90 mm
Limiting Speed - Oil
9500 rpm
Rows of Balls
Single
Fillet Radius
1.5 mm
Lubricant
Oil Preservative
Bearing Class
Class 6 / P6
Radial Internal Clearance Specification
Normal Clearance
icNumber
7695815
Internal Design
Universal Mounting
Origin
Single Row Angular Contact
Element Material
Bearing Steel
Inner Ring Width
0.91 in, 23 mm
Rolling Element
Ball
I.D.
1.57 in, 40 mm
Ball Material
Steel
Bore Type
Cylindrical
Precision Rating
ABEC 3
Cage Type
Metal
Material
Bearing Steel
Ring Type
Solid Inner Ring and Solid Outer Ring
Flush Ground
Yes
Radial Internal Clearance
Normal
Cage
Sheet Metal
Dynamic Load Rating
49.4 kN
O.D. Type
Cylindrical
Inch/Metric
Metric
No. of Bearings
1
Limiting Speed - Grease
7300 rpm
Seal Material
None
Cage Material
Brass
Static Load Rating
33.5 kN
Locking Device
No Locking Device
Seal Type
Unsealed
Series
7300PJ
Bearing Type
Unmounted, Angular Contact
Weight
1.541 LB
EAN or UPC
97741017497
We're here for you
with Service Centers across the country - We have your back