Find a Service Center
- Spool Valve Motor
- Cast Iron Material
- 7/8-14 Prort Size
- SAE O-Ring Port
- 2 Bolt Mount
description
- Small but powerful, Eaton spool valve motors have the perfect combination of features for a variety of demanding applications, from harvesting equipment to food processing plants. With hydrodynamic journal bearings optimized for long life, these spool valve motors distribute pressurized fluid via integrated valve slots into the Gerotor or Geroler® orbit gear set. This results in a spool valve section that can be optimized for low-flow low-speed requirements, keeping equipment performing smoothly.
applications
- Agricultural augers, Harvesters, Seeders, Industrial sweepers and floor polishers
features
- Compact yet powerful
- Extended bearing life
- Increased shaft seal
| Mount Type | 2 Bolt |
| Duty | Standard-Duty |
| Mounting Hole Size | 0.54 in |
| Flow [Max] | 12 gal/min |
| Flange Orientation | Standard |
| Output Shaft Code | 02 |
| Splines | 6 |
| Displacement | 46 cm3/Rev |
| Shaft Type | Splined |
| Port Size & Location | SAE-10 Side |
| Maximum Speed @ Continuous Flow | 969 rpm @ 12 gal/min |
| Series | H Series |
| Flow Rate | 45 lpm |
| Special Features Hardware Code | 00 |
| Motor Type | Spool Valve |
| Intermittent Pressure [Max] | 165 bar |
| Paint/Packaging | Low Gloss Black, Individual Box |
| Torque | 73 Nm |
| Port Size | 7/8-14 |
| Shaft Size & Type | 1 in - 6T Spline |
| Port Location | Side Port |
| RPM [Max] | 969 rpm |
| Output Torque at Rated PSI (inch/pounds) | 646.1 in lb |
| Seal Material | Buna-N |
| Displacement (in³/rev) | 2.8 |
| Special Features Assembly Code | 0 |
| Rotation | Standard Rotation |
| RPM [Min] | 969 rpm |
| Corrosion Resistant | No |
| Material | Cast Iron |
| Case Drain Code | 0 |
| Motor Element | Gerotor |
| Mounting Holes | 0.535 in |
| Port Code | A |
| Paint | Primer Low Gloss Black |
| Bolt Circle Dia. | 4.19 in |
| Special Features | None |
| Pressure [Max] | 1800 psi |
| Paint Code | A |
| Port Type | SAE O-Ring |
| Case Drain | None |
| Pilot Diameter | 3.25 in |
| Inlet Pressure [Max] | 2500 psi |
| Mounting Type Code | A |
| Weight | 11.2 LB |
