Find a Service Center
- 1/8" Shaft, Stainless Steel, Radially Assembled Type, Stacked
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Thickness | 0.015 in |
| Edge Margin | 0.03 in |
| Outside Dia. | 0.23 in |
| Series | E |
| Plating | N/A |
| Shaft Dia. | 0.125 in |
| Thrust Ring Safety Factor of 3 Pr Lb | 66 lbf |
| Load Capacity [Max] | 65 lbs |
| Inch/Metric | Inch |
| Type | Radially Assembled |
| Tape Width | 0.5 in |
| Tape Rings Stack | 250 |
| Clearance Installed in Groove | 0.24 in |
| Material | Stainless Steel (PH15-7, PH17-7) |
| Package Type | Stacked |
| RPM Limit | 35000 rpm |
| Groove Depth | 0.015 in |
| Length of Stack | 3.75 in |
| Limiting Speed | 35000 rpm |
| Thrust Groove Safety Factor of 2 Pg Lb | 45 lbf |
| Tape Length of Stack | 3.75 in |
| Finish | None |
| Weight | 0.002 LB |
| EAN or UPC | 721717017494 |
