Find a Service Center
Alternate Products
- Series E Radially Assembled Retaining Ring
- 0.125 in Shaft Size
- 0.015 in Thick
- Carbon Steel
- Phosphate Finish
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Groove Depth | 0.015 in |
| Series | E |
| Length of Stack | 3.75 in |
| Inch/Metric | Inch |
| Type | Radially Assembled |
| Tape Length of Stack | 3.75 in |
| Thickness | 0.015 in |
| Material | Carbon Steel |
| Clearance Installed in Groove | 0.24 in |
| Package Type | Stacked |
| Tape Rings Stack | 250 |
| Load Capacity [Max] | 65 lbs |
| Outside Dia. | 0.23 in |
| Thrust Ring Safety Factor of 3 Pr Lb | 66 lbf |
| Thrust Groove Safety Factor of 2 Pg Lb | 45 lbf |
| Limiting Speed | 35000 rpm |
| Tape Width | 1/2 in |
| Edge Margin | 0.03 in |
| Plating | Phosphate |
| Shaft Dia. | 0.125 in |
| RPM Limit | 35000 rpm |
| Finish | Phosphate |
| Weight | 0.002 LB |
| EAN or UPC | 721717022467 |
