Find a Service Center
Alternate Products
- Series E Radially Assembled Retaining Ring
- 0.125 in Shaft Size
- 0.015 in Thick
- Carbon Steel
- Phosphate Finish
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Tape Width | 1/2 in |
| Series | E |
| Thrust Ring Safety Factor of 3 Pr Lb | 66 lbf |
| Tape Rings Stack | 250 |
| Finish | Phosphate |
| Shaft Dia. | 0.125 in |
| Thickness | 0.015 in |
| Type | Radially Assembled |
| Limiting Speed | 35000 rpm |
| RPM Limit | 35000 rpm |
| Length of Stack | 3.75 in |
| Clearance Installed in Groove | 0.24 in |
| Package Type | Stacked |
| Material | Carbon Steel |
| Tape Length of Stack | 3.75 in |
| Outside Dia. | 0.23 in |
| Edge Margin | 0.03 in |
| Load Capacity [Max] | 65 lbs |
| Groove Depth | 0.015 in |
| Thrust Groove Safety Factor of 2 Pg Lb | 45 lbf |
| Inch/Metric | Inch |
| Plating | Phosphate |
| Weight | 0.002 LB |
| EAN or UPC | 721717022467 |
