Find a Service Center
Alternate Products
- Series E Radially Assembled Retaining Ring
- 0.156 in Shaft Size
- 0.025 in Thick
- Carbon Steel
- Phosphate Finish
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Load Capacity [Max] | 175 lbs |
| Thrust Groove Safety Factor of 2 Pg Lb | 75 lbf |
| Outside Dia. | 0.282 in |
| Thickness | 0.025 in |
| Inch/Metric | Inch |
| Plating | Phosphate |
| Shaft Dia. | 0.156 in |
| RPM Limit | 31000 rpm |
| Tape Rings Stack | 250 |
| Edge Margin | 0.04 in |
| Thrust Ring Safety Factor of 3 Pr Lb | 178 lbf |
| Finish | Phosphate |
| Series | E |
| Package Type | Stacked |
| Groove Depth | 0.02 in |
| Tape Width | 5/8 in |
| Type | Radially Assembled |
| Limiting Speed | 31000 rpm |
| Tape Length of Stack | 6.25 in |
| Clearance Installed in Groove | 0.295 in |
| Length of Stack | 6.25 in |
| Material | Carbon Steel |
| Weight | 0.005 LB |
| EAN or UPC | 721717023778 |
