Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
Radially installed into machined grooves on shafts (external)
Accommodate lower thrust loadings than axial retaining rings
Do not have lug holes: Easy to install using retaining ring applicators
Provide protruding “shoulders” for effective retention of assemblies
Economical alternative to Axially Assembled external tapered section rings
Shaft Dia.
0.188 in
Material
Carbon Steel
Plating
Phosphate
Limiting Speed
30000 rpm
Series
E
Groove Depth
0.02 in
Type
Radially Assembled
Inch/Metric
Inch
Finish
Phosphate
Load Capacity [Max]
190 lb
Edge Margin
0.04 in
Clearance Installed in Groove
0.35 in
Thickness
0.0250 in
Package Type
Snap Pack
Weight
0.036 LB
EAN or UPC
721717229583
Pre-Packed Quantities
My Applied Catalog
We're here for you
with Service Centers across the country - We have your back
Find a Service Center
