Find a Service Center
- 1/4" Shaft, Stainless Steel, Radially Assembled Type, Stacked
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| RPM Limit | 25000 rpm |
| Edge Margin | 0.04 in |
| Tape Length of Stack | 6.25 in |
| Limiting Speed | 25000 rpm |
| Clearance Installed in Groove | 0.54 in |
| Series | E |
| Plating | N/A |
| Load Capacity [Max] | 255 lbs |
| Thickness | 0.025 in |
| Groove Depth | 0.02 in |
| Material | Stainless Steel (PH15-7, PH17-7) |
| Package Type | Stacked |
| Thrust Ring Safety Factor of 3 Pr Lb | 259 lbf |
| Tape Rings Stack | 250 |
| Length of Stack | 6.25 in |
| Tape Width | 1 in |
| Inch/Metric | Inch |
| Outside Dia. | 0.527 in |
| Thrust Groove Safety Factor of 2 Pg Lb | 115 lbf |
| Shaft Dia. | 0.250 in |
| Finish | None |
| Type | Radially Assembled |
| Weight | 0.02 LB |
| EAN or UPC | 721717005125 |
