Find a Service Center
Alternate Products
- Series E Radially Assembled Retaining Ring
- 0.375 in Shaft Size
- 0.035 in Thick
- Carbon Steel
- Phosphate Finish
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Load Capacity [Max] | 690 lbs |
| Shaft Dia. | 0.375 in |
| Package Type | Stacked |
| RPM Limit | 20000 rpm |
| Edge Margin | 0.072 in |
| Thickness | 0.035 in |
| Tape Rings Stack | 250 |
| Thrust Ring Safety Factor of 3 Pr Lb | 700 lbf |
| Tape Width | 1.25 in |
| Limiting Speed | 20000 rpm |
| Material | Carbon Steel |
| Groove Depth | 0.036 in |
| Series | E |
| Thrust Groove Safety Factor of 2 Pg Lb | 315 lbf |
| Length of Stack | 8.75 in |
| Inch/Metric | Inch |
| Outside Dia. | 0.66 in |
| Plating | Phosphate |
| Type | Radially Assembled |
| Clearance Installed in Groove | 0.68 in |
| Finish | Phosphate |
| Tape Length of Stack | 8.75 in |
| Weight | 0.001 LB |
| EAN or UPC | 721717036303 |
