Find a Service Center
- 1/2" Shaft, Stainless Steel, Radially Assembled Type, Stacked
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Thrust Ring Safety Factor of 3 Pr Lb | 1127 lbf |
| Tape Width | 2 in |
| Thickness | 0.042 in |
| Finish | None |
| Inch/Metric | Inch |
| Package Type | Stacked |
| Clearance Installed in Groove | 0.82 in |
| Series | E |
| Limiting Speed | 14000 rpm |
| Length of Stack | 8.4 in |
| Shaft Dia. | 0.500 in |
| Plating | N/A |
| Material | Stainless Steel (PH15-7, PH17-7) |
| Load Capacity [Max] | 1110 lbs |
| Tape Rings Stack | 200 |
| Groove Depth | 0.052 in |
| Outside Dia. | 0.8 in |
| RPM Limit | 14000 rpm |
| Tape Length of Stack | 8.4 in |
| Type | Radially Assembled |
| Edge Margin | 0.104 in |
| Thrust Groove Safety Factor of 2 Pg Lb | 600 lbf |
| Weight | 0.027 LB |
| EAN or UPC | 721717006276 |
