Find a Service Center
- 1/2" Shaft, Stainless Steel, Radially Assembled Type, Stacked
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Groove Depth | 0.052 in |
| Tape Width | 2 in |
| Series | E |
| Type | Radially Assembled |
| Thrust Ring Safety Factor of 3 Pr Lb | 1127 lbf |
| Material | Stainless Steel (PH15-7, PH17-7) |
| Thickness | 0.042 in |
| Outside Dia. | 0.8 in |
| Finish | None |
| Inch/Metric | Inch |
| Limiting Speed | 14000 rpm |
| RPM Limit | 14000 rpm |
| Thrust Groove Safety Factor of 2 Pg Lb | 600 lbf |
| Length of Stack | 8.4 in |
| Shaft Dia. | 0.500 in |
| Load Capacity [Max] | 1110 lbs |
| Tape Length of Stack | 8.4 in |
| Tape Rings Stack | 200 |
| Package Type | Stacked |
| Edge Margin | 0.104 in |
| Plating | N/A |
| Clearance Installed in Groove | 0.82 in |
| Weight | 0.027 LB |
| EAN or UPC | 721717006276 |
