Find a Service Center
- 5/8" Shaft, Stainless Steel, Radially Assembled Type, Loose
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Edge Margin | 0.14 in |
| Length of Stack | 12.5 in |
| Material | Stainless Steel (PH15-7, PH17-7) |
| Tape Width | 2 in |
| Shaft Dia. | 0.625 in |
| Thrust Groove Safety Factor of 2 Pg Lb | 1050 lbf |
| Type | Radially Assembled |
| Load Capacity [Max] | 1420 lbs |
| Limiting Speed | 12000 rpm |
| Plating | N/A |
| Package Type | Loose |
| Series | E |
| Thrust Ring Safety Factor of 3 Pr Lb | 1441 lbf |
| Tape Rings Stack | 250 |
| Thickness | 0.042 in |
| Outside Dia. | 0.94 in |
| RPM Limit | 12000 rpm |
| Clearance Installed in Groove | 0.96 in |
| Finish | None |
| Tape Length of Stack | 12.5 in |
| Inch/Metric | Inch |
| Groove Depth | 0.07 in |
| Weight | 0.017 LB |
| EAN or UPC | 721717020340 |
