Find a Service Center
- 7/8" Shaft, Stainless Steel, Radially Assembled Type, Loose
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Material | Stainless Steel (PH15-7, PH17-7) |
| Thrust Groove Safety Factor of 2 Pg Lb | 2050 lbf |
| Type | Radially Assembled |
| RPM Limit | 9000 rpm |
| Finish | None |
| Groove Depth | 0.1 in |
| Tape Width | 1 1/2 in |
| Shaft Dia. | 0.875 in |
| Thrust Ring Safety Factor of 3 Pr Lb | 2385 lbf |
| Clearance Installed in Groove | 1.32 in |
| Inch/Metric | Inch |
| Load Capacity [Max] | 2350 lbs |
| Tape Length of Stack | 11 in |
| Thickness | 0.05 in |
| Plating | N/A |
| Package Type | Loose |
| Limiting Speed | 9000 rpm |
| Edge Margin | 0.2 in |
| Length of Stack | 11 in |
| Outside Dia. | 1.3 in |
| Series | E |
| Tape Rings Stack | 200 |
| Weight | 0.019 LB |
| EAN or UPC | 721717019238 |
