Find a Service Center
- 3/32" Shaft, Stainless Steel, Radially Assembled Type, Stacked
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Limiting Speed | 36000 rpm |
| Tape Width | 1 in |
| Plating | N/A |
| RPM Limit | 36000 rpm |
| Thickness | 0.015 in |
| Package Type | Stacked |
| Type | Radially Assembled |
| Tape Length of Stack | 3.75 in |
| Groove Depth | 0.01 in |
| Length of Stack | 3.75 in |
| Inch/Metric | Inch |
| Thrust Groove Safety Factor of 2 Pg Lb | 20 lbf |
| Finish | None |
| Series | E |
| Load Capacity [Max] | 45 lbs |
| Shaft Dia. | 0.094 in |
| Edge Margin | 0.02 in |
| Material | Stainless Steel (PH15-7, PH17-7) |
| Thrust Ring Safety Factor of 3 Pr Lb | 46 lbf |
| Tape Rings Stack | 250 |
| Outside Dia. | 0.187 in |
| Clearance Installed in Groove | 0.2 in |
| Weight | 0.001 LB |
| EAN or UPC | 721717007105 |
