Find a Service Center
- 1" Shaft, Stainless Steel, Radially Assembled Type, Loose
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Edge Margin | 0.148 in |
| RPM Limit | 6500 rpm |
| Length of Stack | 11 in |
| Material | Stainless Steel (PH15-7, PH17-7) |
| Load Capacity [Max] | 2700 lbs |
| Series | SE |
| Groove Depth | 0.082 in |
| Tape Length of Stack | 11 in |
| Limiting Speed | 6500 rpm |
| Shaft Dia. | 0.984 in |
| Plating | N/A |
| Finish | None |
| Tape Width | 1.5 in |
| Clearance Installed in Groove | 1.53 in |
| Thickness | 0.05 in |
| Tape Rings Stack | 200 |
| Inch/Metric | Inch |
| Thrust Groove Safety Factor of 2 Pg Lb | 1750 lbf |
| Type | Radially Assembled |
| Thrust Ring Safety Factor of 3 Pr Lb | 2639 lbf |
| Outside Dia. | 1.5 in |
| Package Type | Loose |
| Weight | 0.023 LB |
| EAN or UPC | 721717108512 |
