MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
7200-PJ and PJD Series bearings are used for heavy one-directional thrust loads or combined radial and thrust loads where thrust is predominant.
Bearing Type
Unmounted, Angular Contact
Cage Material
Bearing Steel
Origin
Single Row Angular Contact
Static Load Rating
54 kN
No. of Rows
Single
icNumber
7695839
Limiting Speed - Grease
4900 rpm
Lubricant
Oil Preservative
Cage Type
Metal
O.D.
4.72 in, 120 mm
Locking Device
No Locking Device
Series
7200PJ
I.D.
2.56 in, 65 mm
Fillet Radius
1.5 mm
Snap Ring
No Snap Ring
Duplex Type
Single
Cage
Sheet Metal
No. of Bearings
1
Seal Type
Unsealed
Temperature Range [Max]
450 °F
Limiting Speed - Oil
6400 rpm
Internal Design
Universal Mounting
Preload Level
Light
Capacity
Standard Capacity
Inner Ring Width
0.91 in, 23 mm
Seal Material
None
Ball Material
Steel
Precision
Standard
Bearing Class
Class 6 / P6
Contact Angle
40 Degree
Width
0.91 in, 23 mm
No. in Set
Single Bearing
Material
Bearing Steel
Precision Rating
ABEC 3
Element Material
Bearing Steel
Rolling Element
Ball
Enclosure
Open
Ring Type
Solid Inner Ring and Solid Outer Ring
Row Type
1
Flush Ground
Yes
Bore Type
Cylindrical
Rows of Balls
Single
Dynamic Load Rating
66.3 kN
Outer Ring Width
0.91 in, 23 mm
Static Load Rating [Max]
12100 lbf
O.D. Type
Cylindrical
Precision Level
Standard (ABEC 1)
Radial Internal Clearance Specification
Normal Clearance
Inch/Metric
Metric
Radial Internal Clearance
Normal
Weight
2.478 LB
EAN or UPC
97741016681
We're here for you
with Service Centers across the country - We have your back