MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
7200-PJ and PJD Series bearings are used for heavy one-directional thrust loads or combined radial and thrust loads where thrust is predominant.
No. of Bearings
1
Duplex Type
Single
Inner Ring Width
1.02 in, 26 mm
Precision
Standard
Snap Ring
No Snap Ring
Precision Rating
ABEC 1
Flush Ground
Yes
O.D. Type
Cylindrical
Ring Type
Solid Inner Ring and Solid Outer Ring
Bearing Type
Unmounted, Angular Contact
Inch/Metric
Metric
Radial Internal Clearance Specification
Normal Clearance
Static Load Rating [Max]
18700 lbf
Fillet Radius
2 mm
Limiting Speed - Grease
3800 rpm
Row Type
1
Temperature Range [Max]
450 °F
Precision Level
Standard (ABEC 1)
Bore Type
Cylindrical
Lubricant
Oil Preservative
Element Material
Bearing Steel
Dynamic Load Rating
83.2 kN
Preload Level
Light
Limiting Speed - Oil
4900 rpm
Contact Angle
40 Degree
Cage
Sheet Metal
Seal Material
None
Rolling Element
Ball
Seal Type
Unsealed
No. of Rows
Single
O.D.
5.51 in, 140 mm
Material
Bearing Steel
Enclosure
Open
Outer Ring Width
1.02 in, 26 mm
Internal Design
Universal Mounting
I.D.
3.15 in, 80 mm
Static Load Rating
73.5 kN
Capacity
Standard Capacity
Locking Device
No Locking Device
icNumber
7695857
Rows of Balls
Single
Series
7200PJ
Bearing Class
Normal / P0
Width
1.02 in, 26 mm
Radial Internal Clearance
Normal
Cage Material
Brass
No. in Set
Single Bearing
Origin
Single Row Angular Contact
Ball Material
Steel
Cage Type
Metal
Weight
3.492 LB
EAN or UPC
97741016827
We're here for you
with Service Centers across the country - We have your back
Find a Service Center
