MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
7300-PJ and PJD Series bearings are used for very heavy one-directional thrust loads or combined radial and thrust loads where thrust is predominant.
Precision Level
Standard (ABEC 1)
icNumber
7695885
Radial Internal Clearance
Normal
Limiting Speed - Grease
11000 rpm
Enclosure
Open
Internal Design
Universal Mounting
No. of Rows
Single
Flush Ground
Yes
Bearing Class
Class 6 / P6
Static Load Rating
15.6 kN
Cage Material
Brass
Precision Rating
ABEC 3
Width
0.67 in, 17 mm
Element Material
Bearing Steel
Rolling Element
Ball
Ball Material
Steel
I.D.
0.98 in, 25 mm
Capacity
Standard Capacity
Row Type
1
Snap Ring
No Snap Ring
Contact Angle
40 Degree
Limiting Speed - Oil
14000 rpm
Material
Bearing Steel
Inch/Metric
Metric
Temperature Range [Max]
450 °F
Static Load Rating [Max]
3080 lbf
O.D.
2.44 in, 62 mm
O.D. Type
Cylindrical
Outer Ring Width
0.67 in, 17 mm
Fillet Radius
1 mm
Preload Level
Light
Ring Type
Solid Inner Ring and Solid Outer Ring
Dynamic Load Rating
26 kN
Series
7300PJ
No. in Set
Single Bearing
Cage
Sheet Metal
Duplex Type
Single
Radial Internal Clearance Specification
Normal Clearance
Cage Type
Metal
Bore Type
Cylindrical
Locking Device
No Locking Device
Rows of Balls
Single
Origin
Single Row Angular Contact
Precision
Standard
Bearing Type
Unmounted, Angular Contact
Seal Type
Unsealed
Seal Material
None
No. of Bearings
1
Lubricant
Oil Preservative
Inner Ring Width
0.67 in, 17 mm
Weight
0.529 LB
EAN or UPC
97741017312
We're here for you
with Service Centers across the country - We have your back