MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
7300-PJ and PJD Series bearings are used for very heavy one-directional thrust loads or combined radial and thrust loads where thrust is predominant.
Snap Ring
No Snap Ring
Contact Angle
40 Degree
Row Type
1
Outer Ring Width
1.14 in, 29 mm
Lubricant
Oil Preservative
Capacity
Standard Capacity
Static Load Rating [Max]
13900 lbf
Cage Type
Metal
Seal Type
Unsealed
Precision Level
Standard (ABEC 1)
O.D. Type
Cylindrical
No. of Bearings
1
Preload Level
Light
Cage
Sheet Metal
icNumber
7695807
Radial Internal Clearance Specification
Normal Clearance
No. of Rows
Single
Fillet Radius
2 mm
Material
Bearing Steel
Dynamic Load Rating
85.2 kN
Bearing Type
Unmounted, Angular Contact
Origin
Single Row Angular Contact
Ball Material
Steel
Ring Type
Solid Inner Ring and Solid Outer Ring
Precision Rating
ABEC 3
Locking Device
No Locking Device
Width
1.14 in, 29 mm
Inch/Metric
Metric
Rows of Balls
Single
Element Material
Bearing Steel
Bearing Class
Class 6 / P6
Internal Design
Universal Mounting
Static Load Rating
60 kN
Limiting Speed - Oil
6600 rpm
Bore Type
Cylindrical
Enclosure
Open
Seal Material
None
Flush Ground
Yes
O.D.
4.72 in, 120 mm
Inner Ring Width
1.14 in, 29 mm
Cage Material
Brass
I.D.
2.17 in, 55 mm
Rolling Element
Ball
Limiting Speed - Grease
5100 rpm
Precision
Standard
Duplex Type
Single
Radial Internal Clearance
Normal
No. in Set
Single Bearing
Temperature Range [Max]
450 °F
Series
7300PJ
Weight
3.281 LB
EAN or UPC
97741017664
We're here for you
with Service Centers across the country - We have your back
Find a Service Center
