MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
7300-PJ and PJD Series bearings are used for very heavy one-directional thrust loads or combined radial and thrust loads where thrust is predominant.
Temperature Range [Max]
450 °F
Precision Level
Standard (ABEC 1)
Precision Rating
ABEC 3
Locking Device
No Locking Device
Outer Ring Width
1.22 in, 31 mm
O.D.
5.12 in, 130 mm
Duplex Type
Single
Inner Ring Width
1.22 in, 31 mm
Lubricant
Oil Preservative
Radial Internal Clearance Specification
Normal Clearance
Internal Design
Universal Mounting
Ball Material
Steel
Capacity
Standard Capacity
Material
Bearing Steel
Rows of Balls
Single
Snap Ring
No Snap Ring
icNumber
7695810
Width
1.22 in, 31 mm
O.D. Type
Cylindrical
Bearing Class
Class 6 / P6
Preload Level
Light
Seal Material
None
Cage Material
Brass
Inch/Metric
Metric
I.D.
2.36 in, 60 mm
No. of Bearings
1
Bearing Type
Unmounted, Angular Contact
Limiting Speed - Grease
4900 rpm
Static Load Rating [Max]
16200 lbf
No. of Rows
Single
Seal Type
Unsealed
Precision
Standard
Cage Type
Metal
Radial Internal Clearance
Normal
Cage
Sheet Metal
Series
7300PJ
Static Load Rating
69.5 kN
Origin
Single Row Angular Contact
Flush Ground
Yes
Row Type
1
Ring Type
Solid Inner Ring and Solid Outer Ring
Fillet Radius
2 mm
No. in Set
Single Bearing
Contact Angle
40 Degree
Limiting Speed - Oil
6400 rpm
Element Material
Bearing Steel
Dynamic Load Rating
95.6 kN
Enclosure
Open
Bore Type
Cylindrical
Rolling Element
Ball
Weight
4.09 LB
EAN or UPC
97741017718
We're here for you
with Service Centers across the country - We have your back