MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
7300-PJ and PJD Series bearings are used for very heavy one-directional thrust loads or combined radial and thrust loads where thrust is predominant.
Cage Material
Brass
Temperature Range [Max]
450 °F
Element Material
Bearing Steel
Inner Ring Width
1.3 in, 33 mm
icNumber
7695812
Bearing Class
Normal / P0
Snap Ring
No Snap Ring
I.D.
2.56 in, 65 mm
Precision
Standard
Capacity
Standard Capacity
Lubricant
Oil Preservative
Preload Level
Light
Limiting Speed - Oil
6000 rpm
Duplex Type
Single
Inch/Metric
Metric
No. in Set
Single Bearing
Contact Angle
40 Degree
Enclosure
Open
Width
1.3 in, 33 mm
O.D. Type
Cylindrical
Cage Type
Metal
Radial Internal Clearance
Normal
Ring Type
Solid Inner Ring and Solid Outer Ring
Static Load Rating
80 kN
Bearing Type
Unmounted, Angular Contact
Locking Device
No Locking Device
Fillet Radius
2 mm
Limiting Speed - Grease
4600 rpm
Row Type
1
Rows of Balls
Single
Series
7300PJ
Flush Ground
Yes
Internal Design
Universal Mounting
Seal Material
None
Precision Level
Standard (ABEC 1)
Seal Type
Unsealed
Dynamic Load Rating
108 kN
Cage
Sheet Metal
Rolling Element
Ball
O.D.
5.51 in, 140 mm
No. of Bearings
1
Radial Internal Clearance Specification
Normal Clearance
No. of Rows
Single
Precision Rating
ABEC 1
Static Load Rating [Max]
19400 lbf
Ball Material
Steel
Origin
Single Row Angular Contact
Outer Ring Width
1.3 in, 33 mm
Bore Type
Cylindrical
Material
Bearing Steel
Weight
4.828 LB
EAN or UPC
97741017794
We're here for you
with Service Centers across the country - We have your back
Find a Service Center
