MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
7300-PJ and PJD Series bearings are used for very heavy one-directional thrust loads or combined radial and thrust loads where thrust is predominant.
Ring Type
Solid Inner Ring and Solid Outer Ring
No. of Bearings
1
Inch/Metric
Metric
Rows of Balls
Single
Rolling Element
Ball
Inner Ring Width
1.61 in, 41 mm
Cage
Sheet Metal
Cage Type
Metal
O.D.
7.09 in, 180 mm
Width
1.61 in, 41 mm
Origin
Single Row Angular Contact
Precision Rating
ABEC 3
No. of Rows
Single
O.D. Type
Cylindrical
Internal Design
Universal Mounting
Cage Material
Brass
Radial Internal Clearance Specification
Normal Clearance
Limiting Speed - Oil
4500 rpm
Dynamic Load Rating
153 kN
Lubricant
Oil Preservative
Seal Material
None
Capacity
Standard Capacity
Static Load Rating [Max]
32100 lbf
Bearing Class
Class 6 / P6
Contact Angle
40 Degree
Preload Level
Light
Element Material
Bearing Steel
Temperature Range [Max]
450 °F
I.D.
3.35 in, 85 mm
Duplex Type
Single
Snap Ring
No Snap Ring
Radial Internal Clearance
Normal
Seal Type
Unsealed
Fillet Radius
2.5 mm
Limiting Speed - Grease
3500 rpm
Static Load Rating
132 kN
Locking Device
No Locking Device
Outer Ring Width
1.61 in, 41 mm
Row Type
1
Bearing Type
Unmounted, Angular Contact
icNumber
7695816
Enclosure
Open
Material
Bearing Steel
No. in Set
Single Bearing
Flush Ground
Yes
Ball Material
Steel
Bore Type
Cylindrical
Precision Level
Standard (ABEC 1)
Precision
Standard
Series
7300PJ
Weight
10.252 LB
EAN or UPC
97741018043
We're here for you
with Service Centers across the country - We have your back