MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
7400-PJ and PJD Series bearings are similar to the 7200-PJ and 7300-PH Series but are heavier sectioned and are used for very heavy thrust loads or combined radial and thrust loads where thrust is predominant.
Element Material
Bearing Steel
O.D.
3.94 in, 100 mm
Inch/Metric
Metric
Capacity
Standard Capacity
Bore Type
Cylindrical
No. of Bearings
1
Row Type
1
Seal Material
None
Radial Internal Clearance
Normal
Material
Bearing Steel
No. in Set
Single Bearing
Ball Material
Steel
No. of Rows
Single
Static Load Rating [Max]
9100 lbf
Bearing Type
Unmounted, Angular Contact
Duplex Type
Single
Cage Material
Brass
Bearing Class
Class 6 / P6
I.D.
1.38 in, 35 mm
O.D. Type
Cylindrical
Locking Device
No Locking Device
Inner Ring Width
0.98 in, 25 mm
Limiting Speed - Oil
8500 rpm
Preload Level
Light
Snap Ring
No Snap Ring
Cage Type
Metal
Precision Rating
ABEC 3
Limiting Speed - Grease
6600 rpm
Width
0.98 in, 25 mm
Enclosure
Open
Series
7400PJ
Rolling Element
Ball
Temperature Range [Max]
450 °F
Dynamic Load Rating
60.5 kN
Outer Ring Width
0.98 in, 25 mm
Cage
Machined Metal
Ring Type
Solid Inner Ring and Solid Outer Ring
icNumber
7695986
Internal Design
Universal Mounting
Precision
Standard
Precision Level
Standard (ABEC 1)
Rows of Balls
Single
Seal Type
Unsealed
Flush Ground
Yes
Static Load Rating
38 kN
Lubricant
Oil Preservative
Contact Angle
40 Degree
Radial Internal Clearance Specification
Normal Clearance
Origin
Single Row Angular Contact
Fillet Radius
1.5 mm
Weight
2.39 LB
EAN or UPC
97741018388
We're here for you
with Service Centers across the country - We have your back