7400-PJ and PJD Series bearings are similar to the 7200-PJ and 7300-PH Series but are heavier sectioned and are used for very heavy thrust loads or combined radial and thrust loads where thrust is predominant.
ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
Capacity
Standard Capacity
Rolling Element
Ball
Temperature Range [Max]
450 °F
Row Type
1
Locking Device
No Locking Device
Inch/Metric
Metric
Bearing Type
Unmounted, Angular Contact
icNumber
7696055
Outer Ring Width
1.14 in, 29 mm
Ball Material
Steel
Snap Ring
No Snap Ring
Radial Internal Clearance Specification
Normal Clearance
Ring Type
Solid Inner Ring and Solid Outer Ring
Static Load Rating
55 kN
Lubricant
Oil Preservative
I.D.
1.77 in, 45 mm
Origin
Single Row Angular Contact
Rows of Balls
Single
Limiting Speed - Oil
6900 rpm
Cage
Machined Metal
Bearing Class
Class 6 / P6
Flush Ground
Yes
Seal Type
Unsealed
O.D. Type
Cylindrical
Precision Level
Standard (ABEC 1)
O.D.
4.72 in, 120 mm
Static Load Rating [Max]
12800 lbf
No. in Set
Single Bearing
Preload Level
Light
Fillet Radius
2 mm
Element Material
Bearing Steel
Bore Type
Cylindrical
Internal Design
Universal Mounting
Duplex Type
Single
No. of Bearings
1
Inner Ring Width
1.14 in, 29 mm
No. of Rows
Single
Precision
Standard
Material
Bearing Steel
Series
7400PJ
Width
1.14 in, 29 mm
Precision Rating
ABEC 3
Radial Internal Clearance
Normal
Dynamic Load Rating
85.2 kN
Cage Type
Metal
Seal Material
None
Limiting Speed - Grease
5300 rpm
Cage Material
Brass
Contact Angle
40 Degree
Enclosure
Open
Weight
3.781 LB
EAN or UPC
97741018425
We're here for you
with Service Centers across the country - We have your back
Find a Service Center
