Find a Service Center
- 1.5 in Shaft Diameter
- 1.92 in Housing Bore Diameter
- 0.25 in Overall Width
- Fluoro Rubber (FKM) Lip Material
- Inch
description
- Radial shaft seals are used between rotating and stationary machine components, or between components in relative motion. CRW1 seals are designed with a metal case, an SKF WAVE lip made of elastomer with higher pumping rate to reduce heat generation, and a garter spring to optimize sealing against the shaft. Most of the seals feature the SKF Bore Tite coating on the outside diameter that helps fill small imperfections in the housing bore.
features
- For oil or grease
- With garter spring
- WAVE lip creates higher pumping rate
- WAVE lip has less friction between shaft and lip
- WAVE lip has a lower temperature at the contact point
| Misalignment & Runout (In. @ Feet Per Minute) | 0.015@1000, 0.010@3600 |
| Lip Material | Fluoro Rubber (FKM) |
| Operating Temperature [Max] | 390 °F |
| Solid | Yes |
| Installation | Housing Press Fit |
| Inch/Metric | Inch |
| Housing Bore Dia. | 1.92 in, 48.72 mm |
| Design | CRW7 |
| Speed | 0.07 ft/min |
| Seal Application | General Purpose |
| Construction | CRW1 |
| Case Material | Steel |
| Cover/Compensation Ring/Plate Required | No |
| Case Design | Metal Case |
| Lip Style | Internal |
| Spring Type | Garter |
| Temperature Range [Max] | 400 °F |
| Spring Material | Stainless Steel |
| Lip Type | Single Lip |
| Case Construction | Steel Case w/o Inner Case |
| Temperature Range [Min] | -40 °F |
| Shaft Dia. | 1.5 in, 38.1 mm |
| Overall Width | 0.25 in, 6.35 mm |
| Operating Temperature [Min] | -5 °F |
| Seal Design | Bonded Design |
| Lubricant | Oil or Grease |
| Surface Speed [Nom] | 3,600 ft/min |
| Pressure | 10 psi |
| Weight | 0.079 LB |
| EAN or UPC | 85311014687 |
