Find a Service Center
Alternate Products
- 3.63 in Shaft Diameter
- 4.38 in Housing Bore Diameter
- 0.38 in Overall Width
- Polyacrylate Elastomer (ACM) Lip Material
- Inch
description
- Radial shaft seals are used between rotating and stationary machine components, or between components in relative motion. CRWH1 seals are designed with a double metal case, an SKF WAVE lip made of elastomer with a higher pumping rate to reduce heat generation, and a garter spring to optimize sealing against the shaft. Most of the seals feature the SKF Bore Tite coating on the outside diameter that helps fill small imperfections in the housing bore.
features
- For oil or grease
- With garter spring
- WAVE lip creates higher pumping rate
- WAVE lip has less friction between shaft and lip
- WAVE lip has a lower temperature at the contact point
| Misalignment & Runout (In. @ Feet Per Minute) | 0.015@1000, 0.010@3000 |
| Seal Application | General Purpose |
| Case Material | Steel |
| Pressure | 10 psi |
| Solid | Yes |
| Lip Type | Single Lip |
| Shaft Dia. | 3.625 in |
| Case Design | Metal Case, Inner Case |
| Lip Style | Internal |
| Installation | Housing Press Fit |
| Seal Type | Oil |
| Speed | 0.07 ft/min |
| Operating Temperature [Max] | 302 °F |
| Construction | CRWH1 |
| Temperature Range [Min] | -40 °F |
| Operating Temperature [Min] | -40 °F |
| Seal Design | SKF Wave |
| Temperature Range [Max] | 300 °F |
| Case Construction | Steel Case w/Inner Case |
| Spring Type | Garter |
| Spring Material | Carbon Steel |
| Bore Sealant | Bore Tite |
| Lip Material | Polyacrylate Elastomer (ACM) |
| Design | CRWH1 |
| Inch/Metric | Inch |
| Overall Width | 0.375 in |
| Lubricant | Oil or Grease |
| Cover/Compensation Ring/Plate Required | No |
| Housing Bore Dia. | 4.376 in |
| Weight | 0.291 LB |
| EAN or UPC | 85311032902 |
