Find a Service Center
Alternate Products
- 0.781 in Shaft Diameter
- 1.499 in Housing Bore
- 0.313 in Overall Width
- Nitrile Rubber (NBR) Lip Material
- SKF Wave Seal
description
- Radial shaft seals are used between rotating and stationary machine components, or between components in relative motion. CRW1 seals are designed with a metal case, an SKF WAVE lip made of elastomer with higher pumping rate to reduce heat generation, and a garter spring to optimize sealing against the shaft. Most of the seals feature the SKF Bore Tite coating on the outside diameter that helps fill small imperfections in the housing bore.
features
- For oil or grease
- With garter spring
- WAVE lip creates higher pumping rate
- WAVE lip has less friction between shaft and lip
- WAVE lip has a lower temperature at the contact point
| Seal Application | General Purpose |
| Solid | Yes |
| Case Construction | Steel Case w/o Inner Case |
| Lip Type | Single Lip |
| Speed | 0.07 ft/min |
| Temperature Range [Min] | -65 °F |
| Bore Sealant | Bore Tite |
| Housing Bore Dia. | 1.499 in |
| Cover/Compensation Ring/Plate Required | No |
| Lubricant | Oil or Grease |
| Misalignment & Runout (In. @ Feet Per Minute) | 0.015@1000, 0.010@3600 |
| Case Material | Steel |
| Pressure | 10 psi |
| Lip Material | Nitrile Rubber (NBR) |
| Installation | Housing Press Fit |
| Temperature Range [Max] | 225 °F |
| Operating Temperature [Max] | 210 °F |
| Operating Temperature [Min] | -40 °F |
| Seal Design | SKF Wave |
| Construction | CRW1 |
| Shaft Dia. | 0.781 in |
| Lip Style | Internal |
| Case Design | Metal Case |
| Spring Type | Garter |
| Seal Type | Oil |
| Spring Material | Carbon Steel |
| Design | CRW1 |
| Overall Width | 0.313 in |
| Inch/Metric | Inch |
| Weight | 0.075 LB |
| EAN or UPC | 85311006088 |
