- 8 in Shaft Diameter
- 10 in Housing Bore Diameter
- 15 mm Overall Width
- Nitrile Rubber (NBR) Lip Material
description
- Radial shaft seals are used between rotating and stationary machine components, or between components in relative motion. CRWH1 seals are designed with a double metal case, an SKF WAVE lip made of elastomer with a higher pumping rate to reduce heat generation, and a garter spring to optimize sealing against the shaft. Most of the seals feature the SKF Bore Tite coating on the outside diameter that helps fill small imperfections in the housing bore.
features
- For oil or grease
- With garter spring
- WAVE lip creates higher pumping rate
- WAVE lip has less friction between shaft and lip
- WAVE lip has a lower temperature at the contact point
| Construction | CRWH1 |
| Material | Alloy Steel with S2 Steel Bit |
| Solid | Yes |
| Operating Temperature [Max] | 210 °F |
| Lip Type | Single Lip |
| Lip Material | Nitrile Rubber (NBR) |
| Housing Bore Dia. | 10.25 in |
| Inch/Metric | Inch |
| Design | CRWH1 |
| Surface Speed [Nom] | 3,600 ft/min |
| Misalignment & Runout (In. @ Feet Per Minute) | 0.015@1000, 0.010@3000 |
| Seal Type | Oil |
| Lubricant | Oil or Grease |
| Spring Material | Carbon Steel Garter |
| Installation | Housing Press Fit |
| Temperature Range [Min] | -40 °F |
| Cover/Compensation Ring/Plate Required | No |
| Overall Width | 0.625 in |
| Pressure | 10 psi |
| Seal Application | General Purpose |
| Operating Temperature [Min] | -40 °F |
| Case Design | Metal Case, Inner Case |
| Case Construction | Steel Case w/Inner Case |
| Lip Style | Internal |
| Seal Design | SKF Wave |
| Shaft Dia. | 8.25 in |
| Temperature Range [Max] | 225 °F |
| Speed | 0.07 ft/min |
| Overall Length | 3.7 in |
| Drive Type | Hex |
| Bit Length | 2.6 in |
| Finish | Full Polish Chrome Holder with Black Oxide Bit |
| Nose Diameter | 1.02 in |
| Drive End | 1.02 in |
| Weight | 1.675 LB |
| EAN or UPC | 85311040129 |

