Find a Service Center
- 1 in Shaft Diameter
- 1.499 in Housing Bore
- 0.25 in Overall Width
- Fluorocarbon Rubber (FKM) Lip Material
- SKF Wave Seal
description
- Radial shaft seals are used between rotating and stationary machine components, or between components in relative motion. CRW1 seals are designed with a metal case, an SKF WAVE lip made of elastomer with higher pumping rate to reduce heat generation, and a garter spring to optimize sealing against the shaft. Most of the seals feature the SKF Bore Tite coating on the outside diameter that helps fill small imperfections in the housing bore.
features
- For oil or grease
- With garter spring
- WAVE lip creates higher pumping rate
- WAVE lip has less friction between shaft and lip
- WAVE lip has a lower temperature at the contact point
| Lip Style | Internal |
| Lip Material | Fluorocarbon Rubber (FKM) |
| Case Design | Metal Case |
| Speed | 0.07 ft/min |
| Lubricant | Oil or Grease |
| Case Material | Steel |
| Material | Alloy Steel |
| Surface Speed [Nom] | 1,179 ft/min |
| Misalignment & Runout (In. @ Feet Per Minute) | 0.015@1000, 0.010@3600 |
| Lip Type | Single Lip |
| Installation | Housing Press Fit |
| Solid | Yes |
| Overall Width | 0.25 in |
| Case Construction | Steel Case w/o Inner Case |
| Operating Temperature [Min] | -5 °F |
| Housing Bore Dia. | 1.499 in |
| Temperature Range [Max] | 400 °F |
| Bore Sealant | Bore Tite |
| Seal Application | General Purpose |
| Spring Material | Carbon Steel |
| Pressure | 10 psi |
| Shaft Dia. | 1 in |
| Inch/Metric | Inch |
| Seal Type | Oil |
| Cover/Compensation Ring/Plate Required | No |
| Operating Temperature [Max] | 390 °F |
| Temperature Range [Min] | -40 °F |
| Seal Design | SKF Wave |
| Design | CRW1 |
| Spring Type | Garter |
| Construction | CRW1 |
| Opening Two | 17 mm |
| Finish | Full Polish Chrome |
| Overall Length | 7.913 in |
| No. of Points | 12 |
| Weight | 0.053 LB |
| EAN or UPC | 85311008136 |
