Find a Service Center
Alternate Products
- Series E Radially Assembled Retaining Ring
- 0.125 in Shaft Size
- 0.015 in Thick
- Carbon Steel
- Phosphate Finish
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Inch/Metric | Inch |
| Tape Length of Stack | 3.75 in |
| Clearance Installed in Groove | 0.24 in |
| Finish | Phosphate |
| Shaft Dia. | 0.125 in |
| Material | Carbon Steel |
| Groove Depth | 0.015 in |
| Series | E |
| Edge Margin | 0.03 in |
| Tape Width | 1/2 in |
| RPM Limit | 35000 rpm |
| Thrust Groove Safety Factor of 2 Pg Lb | 45 lbf |
| Tape Rings Stack | 250 |
| Outside Dia. | 0.23 in |
| Package Type | Stacked |
| Thickness | 0.015 in |
| Type | Radially Assembled |
| Thrust Ring Safety Factor of 3 Pr Lb | 66 lbf |
| Limiting Speed | 35000 rpm |
| Plating | Phosphate |
| Load Capacity [Max] | 65 lbs |
| Length of Stack | 3.75 in |
| Weight | 0.002 LB |
| EAN or UPC | 721717022467 |
