Find a Service Center
Alternate Products
- Series E Radially Assembled Retaining Ring
- 0.125 in Shaft Size
- 0.015 in Thick
- Carbon Steel
- Phosphate Finish
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Tape Rings Stack | 250 |
| Thrust Groove Safety Factor of 2 Pg Lb | 45 lbf |
| Groove Depth | 0.015 in |
| Outside Dia. | 0.23 in |
| Thrust Ring Safety Factor of 3 Pr Lb | 66 lbf |
| Series | E |
| Package Type | Stacked |
| Plating | Phosphate |
| Thickness | 0.015 in |
| Tape Length of Stack | 3.75 in |
| Limiting Speed | 35000 rpm |
| Length of Stack | 3.75 in |
| Tape Width | 1/2 in |
| Shaft Dia. | 0.125 in |
| Material | Carbon Steel |
| Type | Radially Assembled |
| Inch/Metric | Inch |
| Finish | Phosphate |
| Clearance Installed in Groove | 0.24 in |
| RPM Limit | 35000 rpm |
| Load Capacity [Max] | 65 lbs |
| Edge Margin | 0.03 in |
| Weight | 0.002 LB |
| EAN or UPC | 721717022467 |
