Single Row Cylindrical Bore Angular Contact Ball Bearing
Item #102137945
each
features
MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
7300-PJ and PJD Series bearings are used for very heavy one-directional thrust loads or combined radial and thrust loads where thrust is predominant.
Flush Ground
Yes
Precision Rating
ABEC 3
Capacity
Standard Capacity
Material
Bearing Steel
Inch/Metric
Metric
Series
7300PJ
Element Material
Bearing Steel
Bore Type
Cylindrical
O.D. Type
Cylindrical
No. of Bearings
1
Radial Internal Clearance
Normal
Row Type
1
Fillet Radius
2 mm
Inner Ring Width
1.06 in, 27 mm
Preload Level
Normal Axial Clearance
Static Load Rating
51 kN
No. in Set
Single Bearing
Outer Ring Width
1.06 in, 27 mm
Limiting Speed - Oil
7500 rpm
icNumber
7695806
Seal Material
None
Cage Material
Brass
Seal Type
Unsealed
Static Load Rating [Max]
11900 lbf
Precision Level
Standard (ABEC 1)
Limiting Speed - Grease
5800 rpm
Cage
Machined Metal
No. of Rows
Single
Locking Device
No Locking Device
Snap Ring
No Snap Ring
Origin
Single Row Angular Contact
Duplex Type
Single
Cage Type
Metal
O.D.
4.33 in, 110 mm
Rolling Element
Ball
ISO Tolerance
Class 5 / P5
Radial Internal Clearance Specification
Normal Clearance
Bearing Class
Class 6 / P6
Dynamic Load Rating
74.1 kN
Enclosure
Open
Ball Material
Steel
Lubricant
Oil Preservative
Temperature Range [Max]
450 °F
Rows of Balls
Single
Ring Type
Solid Inner Ring and Solid Outer Ring
Precision
Standard
Bearing Type
Unmounted, Angular Contact
I.D.
1.97 in, 50 mm
Contact Angle
40 Degree
Width
1.06 in, 27 mm
Weight
2.632 LB
EAN or UPC
97741036177
We're here for you
with Service Centers across the country - We have your back