MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
7300-PJ and PJD Series bearings are used for very heavy one-directional thrust loads or combined radial and thrust loads where thrust is predominant.
Precision Rating
ABEC 3
Cage
Machined Metal
Element Material
Bearing Steel
Lubricant
Oil Preservative
Seal Type
Unsealed
Limiting Speed - Oil
7500 rpm
O.D.
4.33 in, 110 mm
No. of Bearings
1
Bore Type
Cylindrical
Rolling Element
Ball
Flush Ground
Yes
Seal Material
None
Static Load Rating [Max]
11900 lbf
Radial Internal Clearance
Normal
Precision
Standard
ISO Tolerance
Class 5 / P5
Width
1.06 in, 27 mm
Bearing Type
Unmounted, Angular Contact
No. in Set
Single Bearing
Series
7300PJ
Temperature Range [Max]
450 °F
Duplex Type
Single
I.D.
1.97 in, 50 mm
O.D. Type
Cylindrical
Contact Angle
40 Degree
Cage Material
Brass
No. of Rows
Single
Snap Ring
No Snap Ring
Inch/Metric
Metric
Inner Ring Width
1.06 in, 27 mm
Enclosure
Open
Preload Level
Normal Axial Clearance
Radial Internal Clearance Specification
Normal Clearance
Row Type
1
Bearing Class
Class 6 / P6
Rows of Balls
Single
Material
Bearing Steel
Origin
Single Row Angular Contact
icNumber
7695806
Ball Material
Steel
Ring Type
Solid Inner Ring and Solid Outer Ring
Locking Device
No Locking Device
Cage Type
Metal
Fillet Radius
2 mm
Limiting Speed - Grease
5800 rpm
Dynamic Load Rating
74.1 kN
Outer Ring Width
1.06 in, 27 mm
Precision Level
Standard (ABEC 1)
Static Load Rating
51 kN
Capacity
Standard Capacity
Weight
2.632 LB
EAN or UPC
97741036177
We're here for you
with Service Centers across the country - We have your back