MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
7300-PJ and PJD Series bearings are used for very heavy one-directional thrust loads or combined radial and thrust loads where thrust is predominant.
O.D. Type
Cylindrical
Limiting Speed - Grease
5800 rpm
Material
Bearing Steel
Rows of Balls
Single
Duplex Type
Single
Temperature Range [Max]
450 °F
Capacity
Standard Capacity
O.D.
4.33 in, 110 mm
Row Type
1
Seal Type
Unsealed
Cage Type
Metal
icNumber
7695806
Contact Angle
40 Degree
Fillet Radius
2 mm
Seal Material
None
Precision
Standard
Radial Internal Clearance
Normal
No. of Bearings
1
Static Load Rating [Max]
11900 lbf
Snap Ring
No Snap Ring
Bearing Class
Class 6 / P6
Ball Material
Steel
Radial Internal Clearance Specification
Normal Clearance
Precision Rating
ABEC 3
Internal Design
Universal Mounting
Static Load Rating
51 kN
Series
7300PJ
Cage
Sheet Metal
Rolling Element
Ball
Dynamic Load Rating
74.1 kN
Width
1.06 in, 27 mm
Bore Type
Cylindrical
Element Material
Bearing Steel
No. of Rows
Single
Limiting Speed - Oil
7500 rpm
Bearing Type
Unmounted, Angular Contact
Cage Material
Brass
Origin
Single Row Angular Contact
Locking Device
No Locking Device
Outer Ring Width
1.06 in, 27 mm
Lubricant
Oil Preservative
I.D.
1.97 in, 50 mm
Enclosure
Open
Flush Ground
Yes
Inner Ring Width
1.06 in, 27 mm
Preload Level
Light
No. in Set
Single Bearing
Ring Type
Solid Inner Ring and Solid Outer Ring
Precision Level
Standard (ABEC 1)
Inch/Metric
Metric
Weight
2.67 LB
EAN or UPC
97741017602
We're here for you
with Service Centers across the country - We have your back