Find a Service Center
Alternate Products
- Series SE Radially Assembled Retaining Ring
- 0.984 in Shaft Size
- 0.05 in Thick
- Carbon Steel
- Phosphate Finish
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Edge Margin | 0.164 in |
| Series | SE |
| Shaft Dia. | 0.984 in |
| RPM Limit | 6500 rpm |
| Tape Width | 1 1/2 in |
| Tape Rings Stack | 200 |
| Length of Stack | 11 in |
| Material | Carbon Steel |
| Plating | Phosphate |
| Thickness | 0.05 in |
| Finish | Phosphate |
| Thrust Ring Safety Factor of 3 Pr Lb | 2690 lbf |
| Load Capacity [Max] | 2700 lbs |
| Inch/Metric | Inch |
| Outside Dia. | 1.5 in |
| Thrust Groove Safety Factor of 2 Pg Lb | 1900 lbf |
| Tape Length of Stack | 11 in |
| Type | Radially Assembled |
| Limiting Speed | 6500 rpm |
| Package Type | Stacked |
| Clearance Installed in Groove | 1.53 in |
| Groove Depth | 0.082 in |
| Weight | 0.036 LB |
| EAN or UPC | 721717023433 |
