Find a Service Center
Alternate Products
- Series SE Radially Assembled Retaining Ring
- 0.984 in Shaft Size
- 0.05 in Thick
- Carbon Steel
- Phosphate Finish
description
- Radially assembled, external ‘E’
- Perhaps the most popular and widely used radial retaining ring is the “E” (so named because it is shaped like the letter “E”.) Three prongs make contact with the bottom of the groove and provide a shoulder for effective retention of assemblies.
features
- Radially installed into machined grooves on shafts (external)
- Accommodate lower thrust loadings than axial retaining rings
- Do not have lug holes: Easy to install using retaining ring applicators
- Provide protruding “shoulders” for effective retention of assemblies
- Economical alternative to Axially Assembled external tapered section rings
| Series | SE |
| Material | Carbon Steel |
| Edge Margin | 0.164 in |
| Type | Radially Assembled |
| Tape Rings Stack | 200 |
| Plating | Phosphate |
| RPM Limit | 6500 rpm |
| Length of Stack | 11 in |
| Package Type | Loose |
| Thrust Groove Safety Factor of 2 Pg Lb | 1900 lbf |
| Tape Length of Stack | 11 in |
| Shaft Dia. | 0.984 in |
| Thickness | 0.05 in |
| Groove Depth | 0.082 in |
| Thrust Ring Safety Factor of 3 Pr Lb | 2690 lbf |
| Clearance Installed in Groove | 1.53 in |
| Finish | Phosphate |
| Inch/Metric | Inch |
| Limiting Speed | 6500 rpm |
| Load Capacity [Max] | 2700 lbs |
| Outside Dia. | 1.5 in |
| Weight | 0.023 LB |
| EAN or UPC | 721717015759 |
