Find a Service Center
- 8.25 in Shaft Diameter
- 9.25 in Housing Bore Diameter
- 0.5 in Overall Width
- Nitrile Rubber (NBR) Lip Material
- Inch
description
- Radial shaft seals are used between rotating and stationary machine components, or between components in relative motion. CRWH1 seals are designed with a double metal case, an SKF WAVE lip made of elastomer with a higher pumping rate to reduce heat generation, and a garter spring to optimize sealing against the shaft. Most of the seals feature the SKF Bore Tite coating on the outside diameter that helps fill small imperfections in the housing bore.
features
- For oil or grease
- With garter spring
- WAVE lip creates higher pumping rate
- WAVE lip has less friction between shaft and lip
- WAVE lip has a lower temperature at the contact point
| Operating Temperature [Min] | -40 °F |
| Construction | CRWH1 |
| Case Material | Steel |
| Seal Design | SKF Wave |
| Case Design | Metal Case, Inner Case |
| Seal Type | Oil |
| Overall Width | 0.5 in |
| Design | CRWH1 |
| Lubricant | Oil or Grease |
| Material | Alloy Steel with S2 Steel Bit |
| Speed | 0.07 ft/min |
| Lip Type | Single Lip |
| Installation | Housing Press Fit |
| Housing Bore Dia. | 9.252 in |
| Shaft Dia. | 8.25 in |
| Inch/Metric | Inch |
| Lip Material | Nitrile Rubber (NBR) |
| Pressure | 10 psi |
| Spring Type | Garter |
| Solid | Yes |
| Bore Sealant | Bore Tite |
| Spring Material | Carbon Steel |
| Operating Temperature [Max] | 210 °F |
| Finish | Full Polish Chrome Holder with Black Oxide Bit |
| Bit Length | 2.05 in |
| Drive Type | Hex |
| Overall Length | 2.8 in |
| Nose Diameter | 0.59 in |
| Drive End | 0.67 in |
| Weight | 1.642 LB |
| EAN or UPC | 85311517508 |
