MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
7200-PJ and PJD Series bearings are used for heavy one-directional thrust loads or combined radial and thrust loads where thrust is predominant.
Static Load Rating
20.8 kN
Width
0.67 in, 17 mm
Radial Internal Clearance Specification
Normal Clearance
Row Type
1
Precision
Standard
Limiting Speed - Oil
12000 rpm
Duplex Type
Single
Bearing Class
Class 6 / P6
Cage Type
Metal
No. of Bearings
1
Dynamic Load Rating
30.7 kN
Ring Type
Solid Inner Ring and Solid Outer Ring
Preload Level
Light
Precision Level
Standard (ABEC 1)
O.D. Type
Cylindrical
Snap Ring
No Snap Ring
Outer Ring Width
0.67 in, 17 mm
Element Material
Bearing Steel
Bearing Type
Unmounted, Angular Contact
Cage Material
Bearing Steel
Inch/Metric
Metric
Capacity
Standard Capacity
No. of Rows
Single
Cage
Sheet Metal
I.D.
1.38 in, 35 mm
Origin
Single Row Angular Contact
Lubricant
Oil Preservative
Temperature Range [Max]
450 °F
Locking Device
No Locking Device
Contact Angle
40 Degree
Limiting Speed - Grease
9200 rpm
Seal Material
None
Rolling Element
Ball
Rows of Balls
Single
Fillet Radius
1 mm
Internal Design
Universal Mounting
Inner Ring Width
0.67 in, 17 mm
Series
7200PJ
Flush Ground
Yes
Enclosure
Open
No. in Set
Single Bearing
Seal Type
Unsealed
Precision Rating
ABEC 3
Ball Material
Steel
Static Load Rating [Max]
3820 lbf
icNumber
7695828
Material
Bearing Steel
Bore Type
Cylindrical
Radial Internal Clearance
Normal
O.D.
2.83 in, 72 mm
Weight
0.717 LB
EAN or UPC
97741016445
We're here for you
with Service Centers across the country - We have your back
Find a Service Center
