MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
7200-PJ and PJD Series bearings are used for heavy one-directional thrust loads or combined radial and thrust loads where thrust is predominant.
icNumber
7695814
Contact Angle
40 Degree
Duplex Type
Single
Cage
Sheet Metal
Outer Ring Width
0.71 in, 18 mm
Precision Rating
ABEC 3
Series
7200PJ
Limiting Speed - Grease
7700 rpm
Precision Level
Standard (ABEC 1)
Seal Type
Unsealed
Origin
Single Row Angular Contact
Ring Type
Solid Inner Ring and Solid Outer Ring
Lubricant
Oil Preservative
Radial Internal Clearance Specification
Normal Clearance
Bearing Type
Unmounted, Angular Contact
Static Load Rating
26 kN
Ball Material
Steel
Cage Type
Metal
Rows of Balls
Single
Element Material
Bearing Steel
Inner Ring Width
0.71 in, 18 mm
Static Load Rating [Max]
5130 lbf
Preload Level
Light
Rolling Element
Ball
Enclosure
Open
Capacity
Standard Capacity
Cage Material
Bearing Steel
Temperature Range [Max]
450 °F
Internal Design
Universal Mounting
Flush Ground
Yes
I.D.
1.57 in, 40 mm
O.D. Type
Cylindrical
Bore Type
Cylindrical
Seal Material
None
O.D.
3.15 in, 80 mm
Limiting Speed - Oil
10000 rpm
Row Type
1
No. of Rows
Single
Precision
Standard
Locking Device
No Locking Device
Width
0.71 in, 18 mm
Inch/Metric
Metric
Material
Bearing Steel
Snap Ring
No Snap Ring
No. of Bearings
1
Bearing Class
Class 6 / P6
Radial Internal Clearance
Normal
Dynamic Load Rating
36.4 kN
No. in Set
Single Bearing
Fillet Radius
1 mm
Weight
0.913 LB
EAN or UPC
97741016483
We're here for you
with Service Centers across the country - We have your back
Find a Service Center
