MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
7200-PJ and PJD Series bearings are used for heavy one-directional thrust loads or combined radial and thrust loads where thrust is predominant.
I.D.
1.77 in, 45 mm
Precision
Standard
Duplex Type
Single
Outer Ring Width
0.75 in, 19 mm
Bearing Type
Unmounted, Angular Contact
Cage Type
Metal
Precision Level
Standard (ABEC 1)
Precision Rating
ABEC 3
Inch/Metric
Metric
Enclosure
Open
Flush Ground
Yes
Static Load Rating [Max]
5220 lbf
Capacity
Standard Capacity
Element Material
Bearing Steel
No. in Set
Single Bearing
Bore Type
Cylindrical
Seal Material
None
Seal Type
Unsealed
O.D. Type
Cylindrical
Series
7200PJ
Cage
Sheet Metal
Lubricant
Oil Preservative
Preload Level
Light
Limiting Speed - Oil
9500 rpm
Limiting Speed - Grease
7300 rpm
No. of Rows
Single
Radial Internal Clearance Specification
Normal Clearance
Rows of Balls
Single
Internal Design
Universal Mounting
Rolling Element
Ball
Cage Material
Bearing Steel
Material
Bearing Steel
O.D.
3.35 in, 85 mm
Width
0.75 in, 19 mm
Origin
Single Row Angular Contact
Contact Angle
40 Degree
Temperature Range [Max]
450 °F
Radial Internal Clearance
Normal
Bearing Class
Class 6 / P6
Inner Ring Width
0.75 in, 19 mm
Snap Ring
No Snap Ring
Row Type
1
Static Load Rating
28 kN
Dynamic Load Rating
37.7 kN
Fillet Radius
1 mm
Locking Device
No Locking Device
Ball Material
Steel
No. of Bearings
1
icNumber
7695829
Ring Type
Solid Inner Ring and Solid Outer Ring
Weight
1.003 LB
EAN or UPC
97741016520
We're here for you
with Service Centers across the country - We have your back