MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
7200-PJ and PJD Series bearings are used for heavy one-directional thrust loads or combined radial and thrust loads where thrust is predominant.
Material
Bearing Steel
O.D. Type
Cylindrical
Capacity
Standard Capacity
Radial Internal Clearance Specification
Normal Clearance
No. in Set
Single Bearing
Bearing Class
Class 6 / P6
Element Material
Bearing Steel
Series
7200PJ
Inner Ring Width
0.79 in, 20 mm
Cage Material
Brass
Rolling Element
Ball
Rows of Balls
Single
Origin
Single Row Angular Contact
Dynamic Load Rating
39 kN
Preload Level
Light
Bearing Type
Unmounted, Angular Contact
icNumber
7695824
O.D.
3.54 in, 90 mm
Internal Design
Universal Mounting
Row Type
1
Cage
Sheet Metal
Seal Type
Unsealed
Outer Ring Width
0.79 in, 20 mm
Ball Material
Steel
Temperature Range [Max]
450 °F
No. of Rows
Single
Inch/Metric
Metric
Bore Type
Cylindrical
Locking Device
No Locking Device
I.D.
1.97 in, 50 mm
Static Load Rating
30.5 kN
Precision Rating
ABEC 3
Static Load Rating [Max]
6070 lbf
Contact Angle
40 Degree
Flush Ground
Yes
Enclosure
Open
Precision Level
Standard (ABEC 1)
Snap Ring
No Snap Ring
Limiting Speed - Oil
8300 rpm
Ring Type
Solid Inner Ring and Solid Outer Ring
Width
0.79 in, 20 mm
Fillet Radius
1 mm
Lubricant
Oil Preservative
Limiting Speed - Grease
6400 rpm
Radial Internal Clearance
Normal
Cage Type
Metal
No. of Bearings
1
Duplex Type
Single
Seal Material
None
Precision
Standard
Weight
1.142 LB
EAN or UPC
97741016568
We're here for you
with Service Centers across the country - We have your back